Troubleshooting - Sea-doo GS 5626 Operator's Manual

TROUBLESHOOTING

Monitoring Beeper Coded Signals
The following chart is provided to help in diagnosing the probable source of sim-
ple troubles. You may be able to solve many of these problems rather quickly, but
others may require the skills of a mechanical technician. In such cases, consult
an authorized dealer for servicing.
CODED SIGNALS
2 short beeps (while
installing safety lanyard on
switch).
1 long beep (while
installing safety lanyard on
craft switch or when
pressing start/stop button).
8 short beeps.
Continuously beeps.
Engine will not Start
OTHER OBSERVATION
Engine does not turn over.
Engine turns slowly.
Engine turns normaly.
76
POSSIBLE CAUSE
• Confirms safety lanyard
signal operation.
• Safety lanyard on switch
for more than 10 minutes
without starting engine.
• Bad connection.
• Wrong safety lanyard.
• Defective safety lanyard.
• Salt water in safety lanyard
cap.
• Improper operation of
MPEM or defective wiring
harness.
• Defective MPEM.
• Engine overheats.
POSSIBLE CAUSE
• Safety lanyard removed.
• Burnt fuse.
• Discharged battery.
• Battery connections,
corroded or loose.
• Water flooded engine.
• Discharged or weak battery.
• Close fuel valve.
• Fuel tank empty or water-
contaminated.
• Fuel filter clogged or
water-contaminated.
• Fouled/defective spark
plugs.
• Misuse of choke.
• Fuel flooded engine.
www.SeaDooManuals.net
REMEDY
Engine can be started.
Remove and reinstall safety lanyard
on switch.
Reinstall safety lanyard cap correctly
over switch.
Use a safety lanyard that has been
programmed for the craft.
Use another programmed safety
lanyard.
Clean safety lanyard cap to remove
salt water.
Refer to an authorized dealer.
Refer to an authorized dealer.
See ENGINE OVERHEATING.
REMEDY
Install cap over switch.
Check wiring then replace fuse.
Refer to an authorized dealer.
Refer to an authorized dealer.
Refer to Submerged Watercraft in
SPECIAL PROCEDURES.
Refer to an authorized dealer.
Turn fuel valve to ON position.
Refill. Syphon and fill with fresh fuel.
Clean, check fuel tank for water.
Replace.
Use only with cold engine. Replace
spark plugs.
Replace spark plugs.