Maintenance; Lubrication - Sea-doo GS 5626 Operator's Manual

MAINTENANCE

WARNING
Only perform procedures as de-
tailed in this Guide. It is recom-
mended that the assistance of an
authorized dealer be periodically
obtained on other components/
systems not covered in this Guide.
Unless otherwise specified, en-
gine must not be running and the
safety lanyard must be removed
for all maintenance procedures.

Lubrication

Use SEA-DOO synthetic grease and
lubricate every 10 hours. Proceed as
follows:
Remove seat(s) to expose engine
compartment (for the XP Limited, re-
move rear access panel).
On SPX, GS and GSX Limited, remove
vent tube support.
PTO Flywheel
All Models Except XP Limited
Remove the wing nuts, washers and
pull out PTO flywheel guard.
WARNING
Always remove safety lanyard
cap from its receptacle to prevent
accidental engine starting before
rem o vin g th e PT O flyw he el
guard.
60
F06I04Y
GS, GTS AND GTI MODELS
1. Flywheel guard
2. Wing nuts
F01I0AY
SPX, GSX LIMITED AND GTX LIMITED
1. Flywheel guard
2. Wing nuts
Using a grease gun, carefully lubricate
PTO flywheel at grease fitting until
boot is just beginning to expand.
Immediately stop lubricating as
soon as boot begins to expand.
www.SeaDooManuals.net
2
2
1
-
CAUTION
1