The 1.4.x and 2.x version WS5100 switches have LED behavior that differs from the new 3.o baseline switch.
The 3.0 version switch does not have the same "standby" switch LED functionality that was present in the
1.4.x and 2.x baselines. Additionally, the new 3.0 version switch has a cluster functionality resulting in LED
behavior previously unseen in the earlier baselines. This chapter contains an overview of the differences in
LED behavior between the 1.4.x and 2.x baselines and the WS5100 baseline.
5.1 WS5100 1.4.x and 2.x Baseline LED Behavior
All versions of the WS5100 switch have two vertically-stacked LEDs on its front panel. The LEDs display
three colors (blue, amber, and red), and three lit states (solid, blinking, and off). However, there are some
states that are unique to the WS5100 1.4.x and 2.x version models.
5.1.1 Start Up
Event
Power off
Power On Self Test (POST) running
POST succeeded
Software initializing
Software initialized
5.1.2 Configured as a Primary Switch
Event
Active
Monitoring
Standby missing or not enabled
Inactive
WS5100 LED Behavior Comparison
Off
All colors in rotation
Blue solid
Blue solid
Blue blinking
Blue blinking
Blue blinking
Blue blinking
Amber blinking
Top LED
Bottom LED
Off
All colors in rotation
Blue solid
Off
Off
Top LED
Bottom LED
Blue solid
Amber solid
Off
Blue blinking