Motorola WS5100 Series Migration Giude page 155

3. To apply a rule to the ACL created in step 2 above, select it from the ACLs section and click on the
button in the Associated Rules section.
a. Enter a precedence (priority) value between 1 and 5000 in the
The rules within an ACL will be applied to packets based on their precedence value. Rules with
higher precedence are always applied first.
b. Use the Operation
• Permit— This allows the traffic specified in this Filter section.
• Deny— This denies the traffic spcified in the Filter section.
• Mark— This marks the priority or type of service of the traffic in the Filter section.
c. In Attribute to mark section, select
d. In the Filters section, select a
e. Enter the Source Address, if the source wildcard mask is set to host.
f. Similarly, in the Filters section, select a
g. Enter the Destination
h. You can filter traffic based on the VLAN ID, ethernet type and mark packets using 802.1p.
i. Define a WLAN Index
j. To select a VLAN ID, select the VLAN ID checkbox and enter the VLAN ID.
k. To select a Ethertype, use the drop down box and select ARP.
l. Click OK to apply the changes and close the dialog box.
drop-down menu to define a permit, deny or mark designation for the ACL.
802.1p or TOS
Source Wildcard/Mask
Destination Wildcard/Mask
Address, if the Destination wildcard mask is set to host.
(between 1 -32) to associate an existing WLAN with this ACL Rule.
Precedence field.
if operation is set as mark.
and enter the value— any.
and enter the value— any.
10-15
ACL
Add