Powering On A Switch - Allied Telesis AT-9424Ts Installation Manual

Chapter 3: Preparing the Switches

Powering on a Switch

50
To power on a switch, perform the following procedure:
1. Position the power cord retaining clip in the up position, as shown in
Figure 19.
1 0 0 - 2
Figure 19. Power Cord Retaining Clip in the Up Position
2. Plug the power cord into the AC power connector on the back panel of
the unit (see Figure 20).
Warning: Power cord is used as a disconnection device. To de-
energize equipment, disconnect the power cord.
Warning: This unit might have more than one power cord. To
reduce the risk of electric shock, disconnect all power cords
before servicing the unit.
Figure 20. Connecting the AC Power Cord
4 0 V A
~
C

32
1 0 0 - 2
4 0 V A
~
C

5