Assigning The Static Module Id Number 1 To The Master Switch - Allied Telesis AT-9424Ts Installation Manual

Chapter 3: Preparing the Switches

Assigning the Static Module ID Number 1 to the Master Switch

56
This procedure explains how to assign the static module ID number 1 to
the master switch of the stack. If the switch will be a member switch, go to
the next procedure for instructions on how to assign it a stack ID number.
This procedure assumes that you have already established a local
management session with the device that is to be the master switch of the
stack. For instructions, refer to "Starting a Local Management Session" on
page 52.
To assign the stack ID number 1 to the master switch, perform the
following procedure:
1. Enter the following command to view the switch's current module ID
assignment:
show stack
Note
If the switch displays the message "CLI Command Not Found or
Ambiguous," the AT-S63 Management Software on the unit needs
to be updated. For instructions, refer to "Updating the AT-S63
Management Software" on page 55.
An example of the display is shown in Figure 23.
Local MAC Addr
Standalone Mode ID
Stack Mode
Stack ID
Stack Priority
Figure 23. SHOW STACK Command
This command displays the following information:
Table 9. SHOW STACK Command
Field
Local MAC Addr
Standalone Mode ID
:00:30:84:00:00:03
:1
:AUTO
:1
:16
Description
The MAC address of the switch.
The module ID number of the switch
when the device is not a part of a stack.
This parameter can be ignored.