Chapter 1 Overview - Allied Telesis AT-9424Ts Installation Manual

Chapter 1
Overview
This guide explains how to install the AT-9424Ts, AT-9424Ts/XP and
AT-9448Ts/XP Gigabit Ethernet Switches as an AT-9400Ts Stack. This
chapter contains the following sections:
 "Switch Descriptions" on page 16
 "10/100/1000Base-T Twisted Pair Ports" on page 19
 "SFP Transceiver Slots" on page 21
 "XFP Transceiver Slots" on page 22
 "Redundant Twisted Pair Ports" on page 23
 "Compact Flash Card Slot" on page 24

"Port LEDs" on page 25

"System LEDs" on page 27

"Stack LEDs" on page 28

"AT-StackXG Stacking Module" on page 29

"Terminal Port" on page 30

"AT-RPS3204 Redundant Power Supply" on page 31

"AC Power Connector" on page 32
Note
Allied Telesis recommends you read Chapter 1, "Overview," and
Chapter 2, "AT-9400Ts Stacks," in the AT-S63 Management
Software Features Guide before you begin to install the stack.
Note
You should not begin the installation procedures in this guide until
you have read the Software Release Notes that are included with
the latest release of the AT-S63 Management Software. The Notes
list the features that AT-9400Ts Stacks support. Stacks may not be
suitable for all network environments because they do not support all
of the same features as stand-alone AT-9400 Switches. If your
network requirements include features that are not supported in a
stack, install the switches as stand-alone devices.
15