Copy On The Océ Tds400 - Oce TDS400 Quick Reference Manual

Copy on the Océ TDS400
Connect the scanner to the controller to copy.
▼
Make a copy
Insert the original face down.
1
Align the original right along the original guideline on the scanner feed table.
2
You can see the line (see figure 4).
The scanner moves the original approximately 1 cm to a defined position.
Press the 'start' key
3
The printer prints the copy.
[4] Insert the original
▼
Stop a job
Press the Cancel key.
1
Move of the original stops.
The scanner display shows the message 'Remove original', 'Press cancel'.
2
Open the scanner cover and remove the original (see figure 24).
3
Close the cover.
4
Press the Cancel key. The message disappears on the scanner display.
26 Océ TDS400 Quick Reference Manual
to copy.