Oce TDS400 Quick Reference Manual page 46

[14] Change the position of the roll
Feed the material between the input guide platen against the rollers.
8
Turn the rollers until you can see the material (see figure 15). Also refer to the
9
label inside of the drawer.
[15] Feed the material
If you insert a roll with another material, use the printer operator panel to set
10
the correct material.
If you insert a roll with a different width, use the printer operator panel to set
the correct width. See for complete information 'How to program media
settings' on page 49.
See 'How to cut the paper to get a straight leading strip' on page 49 to cut the
paper to get a straight leading strip, or continue with the next step.
Close the drawer.
11
Press the 'on-line' key.
12
46 Océ TDS400 Quick Reference Manual