The Display - Oce TDS400 Quick Reference Manual

▼
Set the printer on-line
Press the green 'on-line' key.
1
The printer is prepared to print. The 'on-line' light is on.
The 'next/select' key
enter a menu on a lower level.
The 'previous' key
The browse keys (left
previous option.

The display

The display shows the feedback about print job status (see tables below) in
normal mode. In off-line mode it shows the 'off-line' menu (see figure 3 on
page 19).
Status Messages
Status messages Explanation
Off-line
Reset printer
Connecting.....
Printer asleep
Please wait
Printer ready
Preparing job
Printing
Load roll 1
A2
Paper
Load roll 2
A2
Paper
Manual feed
A2
Paper
The Océ TDS400 to print
To select an option in the menu. If a submenu is present,
Press this key to go one level up in the menu.
Use these two keys to display the next or
, right )
The printer is off-line.
Change options.
Turn the printer off and turn the printer on.
There is no communication between the controller and the
printer.
Wait until there is communication.
The printer is in low power mode.
The energy is saved.
The printer downloads the language.
Wait until the printer is prepared to operate.
The printer is prepared to print.
The printer prepares a print or copy job.
The printer prints.
The printer detects that the required media is not available on
roll 1.
Fill roll 1 with the indicated media.
The printer detects that the required media is not available on
roll 2.
Fill roll 2 with the indicated media.
The printer detects that the required media is not available in
the manual feed.
Put the required media in the manual feed.
15