The Display - Oce TDS400 Quick Reference Manual

The zoom key
(left
down ) to adjust the zoom value with an accuracy of 1 percent.
The exposure key
browse keys to change the exposure value.
The media key

The display

The display shows the feedback about the scan/copy job status (see table
below) in normal mode. In off-line mode it shows the off-line menu (see figure
6 on page 31 and 7 on page 32).
Status Messages
Status messages
Scanner ready
+
Connecting.....
Scanner asleep
Scanner running
Please wait
Remove original
Press <cancel>
Original too long
Press <cancel>
Wrong original type
Press <cancel>
Set closed
Reset scanner
28 Océ TDS400 Quick Reference Manual
Enters the zoom mode. The icon flashes. Use the browse keys
right ) to browse the preset zoom values. Use the browse keys (up
,
enters the exposure mode. The icon flashes. Use the
Select roll 1, roll 2 or manual feed. The equivalent icon is on.
Explanations
The scanner is prepared to scan.
= add Add an original to the set and press the start key
= close After the last scan of the set, remove the original and
press the start key
There is no communication between the controller and
the printer.
Wait until the there is communication.
The printer is in low power mode.
The scanner scans.
The scanner downloads the languages.
There is an original on the table during the turn on of the
scanner.
The message appears if you pressed the 'cancel' key
while you scan.
Remove the original.
Press cancel.
Use an original shorter than 15 meter.
This message shows when you select 'Background com-
pensation' and 'Blueprint' as original.
Press cancel.
You closed the copy set.
Turn the scanner on and off.
.
to close the set
,
.