The Scan Settings - Oce TDS400 Quick Reference Manual

The scan settings

Press the 'Extra' key on the scanner operator panel to access the settings for
scan to file (see figure 7 on page 32). The following options are available in the
'File' menu:
You can store your scan either in the temporary storage on the controller or you
can store it on a network destination. You can define a maximum of six
destinations in the Océ Scan Manager application. You can select one of these
destinations on the scanner operator panel.
A Check print is a print from the scanned original. You can turn
Check print
the check print on or off.
The Océ TDS400 scan-to-file option can scan three
File resolution
resolutions: 200, 300 or 400 dots per inch (DPI). The higher the resolution, the
better the image quality. Higher resolution also causes larger sizes of files.
To define format of the scanned files, select between TIFF (Tagged
File format
Image File Format), CALS-I (Continuous Acquisition and Life Cycle support),
or PDF (Portable Document Format). PDF can only be defined when
PostScript 3® is enabled in the Océ Settings Editor.
Select this option to decrease the size of the file and get good
Optimise size
quality.
Set the scan size In the 'Original' menu.
Océ Scan logic® 35