Oce TDS400 Quick Reference Manual page 56

[27] Opening the guide plates
Remove the trailing strip of the old tape (see figure 28).
3
[28] Removing the trailing strip of the old tape
Open the front side plate of the roll holder by unscrewing the green knurled nut
4
and remove the old kernel.
Clean the reinforcement knives before you put in a new roll. See
Note:
'Clean the reinforcement knives' on page 63 for more information.
▼
How to insert a new tape roll
Place the new roll and close the side plate. Make certain that the roll is placed
1
with the holes to the back and the protection sheet to the front (see figure 29).
56 Océ TDS400 Quick Reference Manual