Status Messages - Oce TDS400 Quick Reference Manual

Status Messages

Status messages Explanation
Open left cover
Refill toner
Press <on-line>
Conditioning
Printer ready
Roll 1 empty
Printer ready
Roll 2 empty
Printer running
Roll 1 empty
Printer running
Roll 2 empty
Job cancelled
Close roll unit
Sensor not free
Remove paper
Press <on-line>
Paper retracted
Press <on-line>
Copy too short
Remove paper
Press <on-line>
Inputflap open
Close inputflap
Inputflap open
Remove paper
Press <on-line>
Roll 1 empty
Open roll unit
Roll 2 empty
Open roll unit
Wait for folder
Folder is off
Folder belt full
RU tape empty
16 Océ TDS400 Quick Reference Manual
The toner container is empty.
Refill the toner container.
The toner concentration is too low.
Wait until the toner concentration is at the correct level.
The paper roll 1 is empty.
Reload roll 1.
The paper roll 2 is empty.
Reload roll 2.
The paper roll 1 is empty.
Reload roll 1 after the printers stops printing.
The paper roll 2 is empty.
Reload roll 2 after the printers stops printing.
The current print or copy job is cancelled
The roll unit is open.
Close the roll unit.
The paper of one of the rolls is transferred after the marker
(see 'The paper rolls' on page 44) when power is applied to
the printer.
Take the paper back.
Press <on-line>
Put the paper into the manual feed.
Press <on-line>
The length of the print material is less than 420 mm. This can
occur with the manual feed.
Use an original longer than 420 mm.
The input flap is open.
Close the input flap.
The input flap is open during the print process
Remove the paper and press <on-line>.
The paper on roll 1 is empty.
Open the roll unit and replace it.
The paper on roll 2 is empty.
Open the roll unit and replace it.
The communication between the printer and the folder starts up.
The communication between the printer and the folder was
not established.
The belt of the folder is full.
Empty the belt of the folder.
The tape roll of the reinforcement unit is empty.
Open the reinforcement unit and replace the empty tape roll.