Advertisement
I
I
Gemini User's Manual
• •
REMARKS:
When this command is received, the skip-over
•
perforation feature is activated. This feature
•
causes the printer to skip to the next page or
form, when the number of lines left on the
page is equal to n. If n
=
0, the skip-over form
•
feature is deactivated. The value of n should be
between 0 and 255.
•
EXAMPLE:
LPRI NT CH R$(27);"C";CH R$(88);
CHR$(27);"0";
•
LPRINT CHR$(27);"R";CHR$(8);
CH R$(27);"N";CH R$(16);
•
... these commands allow you to print 64 lines
per page. The first line starts 1 inch from the
•
top, and the last line ends 2 inches from the
bottom of the page. The line spacing is 1/8 inch.
•
PURPOSE:
Cancel the skip·over perforation feature.
FORMAT:
ESC "0"
•
CI-I R$(27) CH R$(79)
REMARKS:
When this command is received, the skip-over
•
perforation set by "ESC N n" code and the line
location of the header of the form set by "ESC
•
R n" code are cancelled.
Vertical Tabs
•
PURPOSE:
Advance paper to the next vertical tab.
•
FORMAT:
VT
CHR$(11)
•
REMARKS:
When this command is received, the paper is
advanced to the next vertical tab position. The
•
vertical tab positions are set upon "power up"
or printer reset to lines 6, 12, 18, 24, 30, 36, 42,
•
48, 54, and 60. The vertical tab positions can be
changed using the ESP "P" nn . .. 0 code.
•
PURPOSE:
Change the position of the vertical tabs.
•
FORMAT:
ESP "P" n1 n2 n3 . .. 0
CHR$(27) CHR$(80) CHR$(n1) CHR$(n2)
•
CH R$(n3) ... C H R$(O)
132
•
Advertisement
