Advertisement
I
Gemini User's Manual
.
----------------------
Function
When "on"
When "off"
2-1
No-paper
Gemini signals
The "out-of-paper"
detection
when you are
signal is not
out of paper
sent by Gemini
enabling the
printer to print
with no paper.
2-2
Buffer full
The CR code is
Printing is
ignored, and one
performed each
line of print data
time the CR code
is stored until
is input
memory Is full or
the LF code
is input
2-3
Selection of
7-bit interface
S-bit interface
the number
of bits
2-4
Automatic
CRcode
No line feed is
line feed
automatically
performed by
performs line feed
input of CR code
Figure 4-7_ DIP switch 2 is "on/off" toggles for four important printer
operations.
52
The "on" position is when the toggle is flipped "up"; the
switch is turned "off" when the toggle is pOinted
"down~'
The
switches are numbered on Gemini, with the left-most toggle
identified as "no. 1" when viewed from the rear and above.
Setting the DIP switches involves using the point of a ball-
point pen (or a similar tool that can serve as a small "finger") by
gently flipping each switch either up or down_
Appendices A through F respond to the need for setting the
DIP switches for six popular types of home computers_ Please
refer to these appendices for information about the recommended
settings for your computer. If your computer is not listed in these
appendices, consult your computer's user manual or your Gemini
dealer_
• •
• •
• •
• •
• •
•
• •
• •
• •
• •
• •
•
•
Advertisement
