Advertisement
Gemini User's Manual
To replace the fuse, turn the power switch "off:' Just to be
on the safe side, make sure you unplug the power cord from the
power source. Then remove the platen knob, take out the mounting
screws, and remove the upper casing. To remove the upper casing,
place your fingers on the inside front of the printer with your
thumbs pressing on the outside front of the lower casing. Gently
pull the upper-casing front toward you until it pops free. Set the
upper-casing front on end (next to the printer) so that the short
wires attached to the control panel remain connected.
After removing the casing, check the fuse, which is located
on the fuse board near the power switch. The fuse is a commonly
used type, with a metal strip suspended in a glass and metal case.
If the strip is broken, the fuse is "blown:'
If the fuse is blown, replace it with a BELL's 5MT1.25 (1.25A,
125V) "slo-blo" type fuse, or equivalent. Just slip the old fuse out
and snap the replacement fuse into place in the two clasps (as
shown in Figure 10-3).
Figure 10-1.
Three mounting screws hold the Gemini-15X upper
casing in place.
144
• •
• •
• •
•
• •
• •
• •
•
• •
• •
•
• •
• •
Advertisement
