• •
The Function Codes
~
• •
REMARKS:
When this command is received by the printer,
it causes the paper to be advanced to the top
•
of the next page or form. The initial top of form
is set upon power "on:' The default value of the
' .
page is set to 66 lines, but can be changed
using the ESC "C"
n
and the ESC "C" 0
n
code.
' .
PURPOSE:
Change the setting of the page (form)
to
n lines.
•
FORMAT:
ESC "C"
n
•
CHR$(27) CHR$(67) CHR$(n)
REMARKS:
When this code is received, the length of the
•
page is set to
n
lines. The value of
n
should be
between 1 and 127.
•
PURPOSE:
Change the setting of the form length
to
n inches.
•
FORMAT:
ESC "C" 0
n
•
CHR$(27) CHR$(67) CHR$(O) CHR$(n)
REMARKS:
When this code is received, the length of the
•
page is set to
n
inches. The values of
n
must
be between 1 and 32.
•
PURPOSE:
Change the line location of the header (first
•
line) of the form.
FORMAT:
ESC "R"
n
•
CHR$(27) CHR$(82) CHR$(n)
REMARKS:
This command is used to change the location
•
of the first line on the next page or form. The
location of the first line is given by the value of
•
n,
and must be between 1 and 16. The default
value set upon "power up" or printer reset is
n
=
1.
•
PURPOSE:
Set and enable the skip-over perforation
•
feature.
FORMAT:
ESC "N"
n
•
CHR$(27) CHR$(78) CHR$(n)
•
131