Basic Operation; Switching The Device On/Off - TechniSat DIGIT ISIO STC Quick Start Manual

5 Basic operation

Dear Customer
The following section starts by covering basic operation as well as recurrent operating steps
for the TV. This should make it easier to read the instruction manual, since it avoids
repeated description of identical steps at each individual stage.
If a function or setting for the device has to be different from the basic operation, the
difference in operation is described in detail at the relevant point in the instruction manual.
Your device uses the so-called "On Screen Display". This simplifies operation of the
television since the buttons on the remote control can take on different functions. This
makes it possible to reduce the number of buttons.
In this On Screen Display (abbreviated to OSD), selected functions or settings are
emphasised by means of highlighting.
Furthermore, you will see a line at the bottom edge of the screen in which the various
buttons on the remote control are shown with their current functions.
In this instruction manual, the terms shown in the OSD as well as the buttons to be
pressed are distinguished from the rest of the text by the print format used.
Warning - indicates an important note, which you absolutely should observe in order to
avoid problems with the device, loss of data or unwanted operation.
Tip - indicates a note about the function described as well as other functions
associated with it and any others to be observed with reference to the respective place
in the instruction manual.
5.1 Switching the device on / off
When the device is on standby, you can switch it on by pressing the On / Standby
>
button on the remote control / device.
> When operating normally you can switch the device to standby mode by pressing the
On / Standby button.
When switching the device on / off, also note Point 9.1 in your operating manual.
14