Drilling Template - Defender SN301-8CH Instruction Manual

WIRING ADDENDUM
A D
G
B
C
F
H
K
L
J
E
WIRING INSTRUCTIONS
1. Plug 12V adapter (A) into electrical wall outlet or surge protecting power bar.
2. Plug the single end of the four port power supply (C) into the male end of the 12V adapter (B).
3. Connect the 4PIN DIN female connection on the camera (E) into the 4PIN DIN male connection on the 60ft video
power wire (F).
4. Plug the power jack (G) from the 60ft video/power wire into one of the ports of the four port power supply (D).
5. Attach the BNC to RCA connector (L) to the video inputs (J) on the back of the DVR.
6. Connect the yellow male RCA plug (H) from the 60 ft cable to the BNC to RCA (K) connector on your DVR.
7. Repeat the above steps for all of the included cameras.

DRILLING TEMPLATE

To wall mount the camera, drill three holes using a 3/16" drill bit and the template below. Insert the supplied wall
anchors into holes and secure camera to wall with supplied screws.
.................................................................................................Tear Here.............................................................................................
DRILL HOLES IN
DRILL HOLES IN
THESE POSITIONS
THESE POSITIONS
SN301-8CH
86