Wiring Diagram For Cameras; Connecting Additional Devices; Connecting A Usb Mouse - Defender SN301-8CH Instruction Manual

BASIC SETUP
WIRING FOR CAMERAS
A D
G
B
C
F
H
K
L
J
E
INSTRUCTIONS
1. Plug 12V adapter (A) into electrical wall outlet or surge protecting power bar.
2. Plug the single end of the four port power supply (C) into the male end of the 12V adapter (B).
3. Connect the 4PIN DIN female connection on the camera (E) into the 4PIN DIN male connection on the 60ft video
power wire (F).
4. Plug the power jack (G) from the 60ft video/power wire into one of the ports of the four port power supply (D).
5. Attach the BNC to RCA connector (L) to the video inputs (J) on the back of the DVR.
6. Connect the yellow male RCA plug (H) from the 60 ft cable to the BNC to RCA (K) connector on your DVR.
7. Repeat the above steps for all of the included cameras.

CONNECTING ADDITIONAL DEVICES

Plug Mouse into first USB port

CONNECTING A USB MOUSE

It is recommended to connect the included USB mouse
before powering on the DVR. This will speed up the
initializing process as well as make the DVR easier to use.
1. Plug the USB connection on the mouse into the top
USB connection on the back of the DVR.
SN301-8CH
9