Restoring Factory Defaults - Cooper Security i-on 40 Installation Manual

4. Short the Reset Codes pins together
using a screwdriver or jumper link.
(Keep the short on until step 6.)
5. Apply mains power.
The control unit loads the factory default
access codes:
User 1: 1234, Installer: 7890.
(All other users have been deleted.)
After a short pause the keypad display
shows the time and date. The red LEDs
glow to show an alert that the panel lid
is open. The sounders operate.
6. Remove the short from the Reset Codes
pins.
7. Reconnect the battery.
8. Close the control unit lid (to restore the
tamper switch).
9. Key in the Master User code, 1234, to
silence the sirens.
The LEDs around the navigation glow
red to show an alert for a tamper and a
missing battery.
Press Y twice to (if necessary)
acknowledge any alerts.
To force the control unit to check the
battery:
10. Enter Installer Menu and then leave it
again.
The navigation key LEDs should now
glow green.
Note: The log is protected and cannot be
erased by the Installer.
Restoring Factory
Defaults
If you wish to restore all factory default
options then:
1. From the Installer Menu select System
Options – Restore Defaults – Factory Defaults.
The display asks for confirmation.
2. Press Y to load defaults.
(Press X to go back to the Installer
Menu without changing defaults.)
The display asks you to select Partition
Mode or Part Set Mode.
3. Press A or B to select the desired mode.
The display asks you to select the zone
wiring type.
Page 14
4. Press u or n to display the desired
wiring type on the bottom line of the
display and then press Y to select it.
The system loads all defaults except for
Access Codes and the Log.
The display shows:
Factory defaults
5. Leave the Installer Menu to save the
change (press X until the display shows
"
Leave Installer mode ?
press Y).
i-on40
restored
" then