Cooper Security i-on 40 Installation Manual page 2

© Cooper Security Ltd. 2010
Every effort has been made to ensure that the contents of this book are correct. However,
neither the authors nor Cooper Security Limited accept any liability for loss or damage caused
or alleged to be caused directly or indirectly by this book. The contents of this book are subject
to change without notice.
Printed and published in the U.K.
This manual applies to the i-on40 control unit with version 2.02 software.
For Your Safety
This book contains several passages alerting you to potential problems or hazards. Each of
these are marked by the words Note, Caution or WARNING.:
Note: Describes conditions that may affect the proper functioning of the
equipment (but will not damage the equipment).
Caution: Describes actions that will physically damage the equipment and
prevent its proper function.
WARNING: Describes actions that are hazardous to health, or cause injury or
death.
Please pay particular attention to these marked passages.
Other Publications for the i-on40:
User Guide
The following guides are available from the Cooper Security website:
www.coopersecurity.co.uk
Administrator's Guide
Programming Reference Guide
Web Server Setup Guide
i-on Updater Installation and
User Guide
Page ii
Instructions for setting and unsetting an alarm system
based on the i-on40.
Detailed notes for the system administrator of an alarm
system based on the i-on40.
A detailed description of the Installer's programming options
available on the i-on40.
Instructions on how to configure a Windows PC or laptop to
use the i-on40's built-in web server for installation
programming.
This booklet shows you how to install i-on Updater on your
PC and use it to update the software on your i-on40 control
unit.