Exit Modes; Maintenance - Cooper Security i-on 40 Installation Manual

i-on40

Exit Modes

When choosing an exit mode for a partition
or a part set, the available options are:
Final Door Use this option to complete
Set setting the system by closing a
door fitted with a Final Exit
zone detector. Note that the
exit time is infinite in this
option.
The system allows a seven
second settling time after
closing a final door.
Note: Do not try to make a PIR
zone act as a Final Exit. Radio
PIR detectors have a "lock out"
period after each activation in
order to conserve battery
power. When you set (or part
set) the system a PIR may still
be in lockout, during which it
cannot send a signal to
complete the setting process.
Timed Set Use this option to make the
system set after a delay. Use
the Exit time menu to choose
the delay.
Instant The system sets immediately
Set and without any tones.
Silent Set The system sets after the exit
time programmed in the
Entry/Exit Time menu but does
not give any exit tones. When
the system sets the keypad
gives a double beep.
The keypad gives a double
beep confirmation tone at the
end of all setting modes.

7. Maintenance

The control unit should be inspected once
per year. At each inspection:
Check the control unit for obvious signs
of damage to the case or its lid.
Check the action of the back tamper.
Check the condition of the control unit
standby battery.
Check the cabling to the keypad(s) for
signs of damage or wear.
Check the keypads for obvious signs of
damage.
Test the action of all buttons on all
keypads.
Clean the keypad surface and display.
To clean the keypad wipe the surface
with a clean soft dry cloth. Do not use
water, solvents or any proprietary
cleaning materials.
Monitor the signal strength and battery
condition of all detectors, radio
keypads, remote controls, PAs and radio
sounders. Test each device. Replace
batteries as recommended by the
manufacturer's instructions.
Gently clean the lenses of any PIRs with
a clean, soft dry cloth. Do not use
water, solvents or any proprietary
cleaning materials.
Walk test all detectors.
Test any external sounders and strobes.
Page 21