Install The Envoy; Find The Envoy Serial Number - enphase Envoy Installation And Operation Manual

Install the Envoy

To install the Envoy, perform the following steps.
BEST PRACTICE: When powered up and connected for the first time, the Envoy may
retrieve an automatic upgrade from Enphase. Because this upgrade may take up to 15
minutes, connect the Envoy first at the site (connect to both AC power and the broadband
router) so that it performs the upgrade well before the solar module installation is complete.
WARNING! Do not remove power from the Envoy if the LCD displays:
"Upgrading. . . Do Not Unplug."

1. Find the Envoy Serial Number

The serial number label is on the back of the Envoy, near the left mounting bracket. You can build the
system map manually, by peeling the serial number label from the Envoy and placing the label on the
installation map, or you can use the ArrayGun feature from the Enphase Installer Toolkit to easily build
and configure a system. Refer to
To manually build the installation map:
a. Remove the Envoy's removable serial number label.
b. Attach the serial number label to the microinverter installation map, or make note of it for
registration in the next step.
If needed, you can find an installation map at the back of the Enphase Microinverter manual.
Menu button
10
http://enphase.com/products/arraygun/
DO NOT route the power
cable or the Ethernet cable
through the cable tray.
 2014 Enphase Energy Inc.
Envoy Installation and Operation
for more information.
Serial
Number
141-00014 Rev 04