Alcatel-Lucent OmniPCX Office Installation Manual page 90

Chapter
4
Choosing the initialization mode
The default mode is dynamic mode.
To choose the initialization mode, refer to the table below.
If
You have a DHCP server
You do not have a DHCP
server
Initializing the IP Touch set
To initialize the IP Touch set, refer to the table below.
Note 1:
In each of the two cases below, you can view the IP Touch set's software version after Step 2 by select-
ing Version in the Main menu.
For an Procedure
initialization
that is
Dynamic mode 1. Connect the power supply.
or Proprietary 2. After initialization phase 2 is completed and before phase 5 starts, press i, then
dynamic mode
3. If the set was previously in static mode, choose IP Parameters from the Main
4. Choose Dynamic and press the OK key.
5. Save by pressing the # key.
6. Exit the Main menu by pressing the * key.
4-46
table 4.21: Initialization modes
Then the required
initialization mode is
Dynamic mode or
Proprietary dynamic mode
Static mode
table 4.22: Initialization procedure
the # key.
The Main menu appears.
menu.
The IP Parameters menu appears.
And
Refer to table: Initialization
procedure
In the case of Proprietary
dynamic mode, the IP address
of the set must be provided by
the Proprietary router.
- Refer to table: Initialization
procedure
- Obtain from your network
administrator:
• An IP address for the
IP Touch set
• The subnetwork mask
• The router address
• The TFTP server
address (master VoIP
board address)