Alcatel-Lucent OmniPCX Office Installation Manual page 86

Chapter
4
The e-Reflexes terminals are connected to:
1. A PC (optional). The PC is a workstation that uses the station's switch function (link
through straight RJ45 cable). The connecting PC does not power; it does not exist on the
Easy e-Reflexes terminal.
RJ45 pin
Outputs
2. The IP network (straight RJ45 cable).
RJ45 pin
Outputs
3. The mains power socket for local power
Pin
Signal
4.4.2.2 Start-up
4.4.2.2.1 Configuration procedure
Depending on the network topology, the configuring of the IP Enablers can be:
- Completely automatic, if they are on the same subnet as Alcatel-Lucent OmniPCX Office
Communication Server: simply connect the terminals to the LAN and connect the power
supply unit. The DHCP server allocates the dynamic IP addresses and the TFTP server
integrated into the CPU-1/CPU-2/CPU-3/CPUe-1/CPUe-2 board downloads the binary into
the IP Enabler (integrated in the terminal).
4-42
1 2 3
TXB+ TXB- RXB+
1 2 3
RXA+ RXA- TXA+
1
A 42 V-
4 5
A1 A2
4 5
2
A 42 V+
6 7 8
RXB- B1 B2
6 7 8
TXA-