Chapter
4
During installation, always take anti-static precautions (wristband, heelpiece, etc.) before
handling the hard disk. Any degradation caused by electrostatic discharges will reduce
the life of the disk.
When going into stand-by mode, wait for the red Power LED to stop flashing before you
remove the module's CPU board. Extracting the disk before the switch to standby is
completed can destroy part of the disk or damage its contents. Never handle the hard
disk until the motor has stopped completely (about 4 seconds after the red Power LED stops
flashing).
4.11.1.4
ADDING AN ADD-ON MODULE
4-88
Figure 4.73: PATA Hard Disk Connection
Figure 4.74: SATA Hard Disk Connection