The Reset Button; Using The Reset Button; The Wifi Button - ZyXEL Communications P-660HW-Tx v3 User Manual

Table 1 LED Descriptions
LED
DSL
INTERNET
Refer to the Quick Start Guide for information on hardware connections.

1.6 The RESET Button

If you forget your password or cannot access the web configurator, you will need
to use the RESET button at the back of the device to reload the factory-default
configuration file. This means that you will lose all configurations that you had
previously and the password will be reset to "broadband1".

1.6.1 Using the RESET Button

Make sure the POWER LED is on (not blinking).
1
To set the device back to the factory default settings, press the RESET button for
2
5 seconds or until the Power LED begins to blink. Do not turn off the device while
the reset is in progress! When the Power LED stops blinking and lights green, the
defaults have been restored and the device restarts.

1.7 The WIFI button

By default, the wireless LAN is on. You can use the WIFI button on the back of the
device to disable or activate the wireless LAN. You can also use it to activate WPS
in order to quickly set up a wireless network with strong security.
P-660HW-Tx v3 User's Guide
COLOR STATUS DESCRIPTION
Green On The DSL line is up.
Blinking The ZyXEL Device is initializing the DSL line.
Off The DSL line is down.
Green On The ZyXEL Device has an IP connection but no traffic.
Your device has a WAN IP address (either static or
assigned by a DHCP server), PPP negotiation was
successfully completed (if used) and the DSL connection
is up.
Blinking The ZyXEL Device is sending or receiving IP traffic.
Red On The ZyXEL Device attempted to make an IP connection
but failed. Possible causes are no response from a DHCP
server, no PPPoE response, PPPoE authentication failed.
Off The ZyXEL Device does not have an IP connection.
Chapter 1 Introducing the ZyXEL Device
27