The Qos General Screen - ZyXEL Communications P-660HW-Tx v3 User Manual

16.3 The QoS General Screen

Use this screen to enable or disable QoS and have the ZyXEL Device automatically
assign priority to traffic according to the IEEE 802.1p priority level, IP precedence
and/or packet length.
Click Advanced > QoS to open the screen as shown next.
Figure 102 Advanced > QoS > General
The following table describes the labels in this screen.
Table 70 Advanced > QoS > General
LABEL
Active QoS
Traffic priority
will be
automatically
assigned by
Apply
Cancel
P-660HW-Tx v3 User's Guide
DESCRIPTION
Select the check box to turn on QoS to improve your network
performance.
You can give priority to traffic that the ZyXEL Device forwards out through
the WAN interface. Give high priority to voice and video to make them
run more smoothly. Similarly, give low priority to many large file
downloads so that they do not reduce the quality of other applications.
These fields are ignored if traffic matches a class you configured in the
Class Setup screen.
If you select ON and traffic does not match a class configured in the
Class Setup screen, the ZyXEL Device assigns priority to unmatched
traffic based on the IEEE 802.1p priority level, IP precedence and/or
packet length. See Section 16.8.4 on page 272
If you select OFF, traffic which does not match a class is mapped to
queue two.
Click this to save your changes.
Click this to restore your previously saved settings.
Chapter 16 Quality of Service (QoS)
for more information.
259