The Www Screen - ZyXEL Communications P-660HW-Tx v3 User Manual

Remote Management and NAT
When NAT is enabled:
• Use the ZyXEL Device's WAN IP address when configuring from the WAN.
• Use the ZyXEL Device's LAN IP address when configuring from the LAN.
System Timeout
There is a default system management idle timeout of 15 minutes (900 seconds).
The ZyXEL Device automatically logs you out if the management session remains
idle for longer than this timeout period. The management session does not time
out when a statistics screen is polling.

18.2 The WWW Screen

To enable Remote Management from the WAN for web access you have two
options: create a dynamic firewall rule or manually create a firewall rule. The
dynamic firewall rule is the simplest but unlike the manual firewall rule option it
does not allow you to specify the source IP address(es) for WAN access.
18.2.0.1 Creating Dynamic WWW rule
Click Advanced > Remote MGMT > WWW and set Access Status to ALL (or
1
LAN & WAN or WLAN & WAN).
Note: IMPORTANT! If you choose WAN it will ONLY allow access from the WAN.
Next click on the option Create a dynamic firewall rule to permit WAN access
2
and click the Apply button.
To disable WAN remote management for Web, simply reverse the above. Be
careful to set the Access Status to either or both LAN and WLAN.
Note: It is recommended if you are allowing WAN access even temporarily to change
the default password (in Maintenance > System > General).
18.2.0.2 Manual WWW Rule
Click Advanced > Remote MGMT > WWW and set Access Status to ALL (or
1
LAN & WAN or WLAN & WAN).
Note: IMPORTANT! If you choose WAN it will ONLY allow access from the WAN.
P-660HW-Tx v3 User's Guide
Chapter 18 Remote Management
281