The Queue Setup Screen - ZyXEL Communications P-660HW-Tx v3 User Manual

16.7.1 The Queue Setup Screen

Use this screen to view or modify the ZyXEL Device's Queue Setup. Click
Advanced > QoS > Queue Setup. The screen appears as shown.
The following table describes the labels in this screen.
Table 74 QoS Queue Setup
LABEL
Interface
No.
Active
Priority
Weight
Weight in
Percent
Shaping Rate
in Percent
Bucket
Size(Bytes)
Drop
Algorithms
Modify
Apply
Cancel
P-660HW-Tx v3 User's Guide
DESCRIPTION
Select through which interface traffic of this queue should go.
This is the index number of this entry.
Select the check box to enable the queue.
This shows the priority of this queue.
This shows the weight of this queue.
This shows the weight of this queue in percentage of all queues with the
same priority.
This shows the maximum transmission rate allowed for traffic on this
queue.
This shows the size of the bucket, which is the maximum amount of bytes
that tokens can be available for instantaneously.
This shows the queue management algorithm used for this queue.
Click the Edit icon to go to the screen where you can edit the queue.
Click the Remove icon to delete an existing queue. Note that subsequent
rules move up by one when you take this action.
Click Apply to save your changes back to the ZyXEL Device.
Click Cancel to begin configuring this screen afresh.
Chapter 16 Quality of Service (QoS)
267