Troy-Bilt LS 33 TB Operator's Manual page 9

Attaching the tongue
1. Remove the two hex bolts and lock nuts on the front of the
reservoir tank.
NOTE: The hardware for attaching the tongue to the
reservoir tank is already inserted into the reservoir tank
brackets.
2. Place the tongue in position and secure with hardware just
removed. See Fig. 3-5.
Hex Bolts
Figure 3-5
3. Remove the reservoir tank from the blocks.
Attaching Beam To Reservoir Tank
1. Stand the wedge, beam, and cylinder assembly upright
with cylinder toward the top.
NOTE: This step will require two people.
2. Remove the hinge pin and cotter pin from the welded
brackets on the beam assembly and move the reservoir
tank assembly in position against the beam.
3. Lift up on the tongue assembly until the holes are aligned
and insert the hinge pin just removed through brackets on
beam and reservoir tank assembly.
Lock Nuts
4. Secure the hinge pin with the cotter pin by bending the
ends of the pin. See Fig. 3-6.
Hinge Pin
5. Secure the beam to the tank by pulling out on the vertical
beam lock and rotating it up and over the edge of the
beam.
Cotter Pin
Figure 3-6
s 3 — a & s
ectiOn sseMbly et
-u 9
p