Troy-Bilt LS 33 TB Operator's Manual page 11

Return Hose:
The return hose is attached to the top of the control valve at the
factory.
1. Loosen the hose clamp on the free end of the hose.
Remove any protective insert from the end of the hose.
2. Remove the protective cap from the fitting on top of the
filter head.
3. Attach the end of the hose to the fitting on top of the filter.
Place the hose clamp at the base of the fitting, tighten
securely and cut the zip tie securing hose guard. See Fig.
3-9.
Filter
Housing
To Reservoir Tank
Figure 3-9
Attaching The Log Cradle
1.
2.
3.
Control
Valve
Return
Hose
4.
Pull the beam lock on the beam support/latch bracket out
and pivot it down. Pull the vertical beam lock on the tank
and pivot it down. Carefully lower the wedge, beam, and
cylinder assembly to the horizontal position. Pull out and
rotate beam lock to secure beam in the horizontal position.
NOTE: The hardware for attaching the log cradle can be
found already inserted into the beam.
Remove the cradle mounting screws from the beam.
Place a log cradle assembly against the lower outside
surface of the beam flange and secure using the four self-
tapping screws previously removed. See Fig. 3-10.
screws
Figure 3-10
Attach second cradle support bracket assembly to the
other side of the beam using the instructions above.
s
ectiOn
Log Cradle
3 — a & s -u
sseMbly et p
11