Troy-Bilt LS 33 TB Operator's Manual page 10

Attaching Engine-Pump Assembly
NOTE: The Engine is secured to the crate by a pair of wood screw.
Remove these before beginning the assembly.
1. Remove the engine mounting hardware from the engine
plate on the tank.
2. Place the engine and pump assembly in position on the
engine mounting bracket with the pump facing towards
the jack stand.
3. Align the holes in the base of the engine with the
appropriate holes in the engine mounting bracket.
4. Secure the engine and pump assembly with the four hex
bolts, bell washers and lock nuts removed earlier. Using a
torque wrench, tighten to 14 ft-lbs. See Fig. 3-7.
Hex Bolt
Bell Washer
Lock Nut
10 s 3— a
ectiOn sseMbly
Figure 3-7
& s -u
et p
Attaching The Hoses
Suction Hose:
The suction hose is attached to the reservoir tank, beneath the
engine mounting bracket.
1. Loosen the hose clamp on the free end of the hose.
Remove any protective insert from the end of the hose.
2. Remove the protective cap from the fitting on the bottom
of the pump (some oil may flow from pump).
3. Attach the end of the suction hose to the fitting on the
bottom of the pump. See Fig. 3-8.
To Filter
Housing
Pressure Hose
Suction Hose
Figure 3-8
4. Place the hose clamp at the base of the fitting and tighten
securely.
Pressure Hose:
The pressure hose is attached to the control valve at the factory.
1. Route the pressure hose between the beam and the
tongue to the top of the pump.
2. Remove the protective hose cover.
3. Secure the pressure hose to the pump and cut the zip tie
securing hose guard. See Fig. 3-8
Hose Clamp
To Reservoir Tank