Fault Messages In Control Panel - Biddle CA2 Manual

M
ANUAL
P
ROBLEM
The display flickers
For units connected to a Daikin system CA
The buttons and
the Daikin control panel do not
function.
The air curtain discharged
unheated air.
The air curtain discharges
unheated or cold air, or does not
function, and the Daikin control
panel shows
5.3

Fault messages in control panel

Version: 6.1 (05-12-2011)
L
IKELY CAUSE
The power supply is too low or
not constant
The length of the control cable
between control panel and the
first unit is too long
on These buttons have no function.
A fault has occurred in the Daikin
system
The Daikin system has
automatically switched the
heating off.
The Daikin system is operating in
defrost mode. This takes 5 to 10
minutes.
.
ä
V and CA Q:
2 2
5.3.1 Reading out faults
Current faults
Current faults are displayed on the Home screen. If a fault has
remedied itself, a corresponding message will be displayed.
When the error message is touched, an explanation of the
actions to be taken appears on the screen. The message
disappears from the Home screen only when the fault has
been remedied.
There may be more than one fault at the same time. You can
read out a list of current error codes via
Menu Maintenance Current faults
> >
No-longer-current faults
If a fault has remedied itself, a corresponding message will be
displayed. Touch this message to display the
read out the last five faults and the times of their occurrence.
W
HAT TO DO
Reduce the brightness of the
display to a level at which
flickering no longer occurs
Remove unnecessary cable length
The air curtain is operated with
the Biddle b-touch control panel.
Check the settings on the Daikin
control panel.
Check the settings on the Daikin
control panel.
Wait until defrosting has been
completed.
.
Fault history
F
AULTS
and to
53