Biddle CA2 Manual page 43

M
ANUAL
54. Strength with door closed
55. Winter setting door
58. Maximum strength
60. Function of input
61a/b. Function of output 1/2
Version: 6.1 (05-12-2011)
See also section 2.8.
Set the minimum fan speed when contact is made with the
input. Use a door switch here to reduce the fan speed when
the door is closed.
This has an effect only when function
Quick speed up Slow speed up
set to or
If the difference between the desired and the actual room
temperature is larger than this value, contact is made. An
automatic sliding door can then be set to half open.
This has an effect only when function
1/2 Winter setting door
is set to
The maximum fan speed can be limited in order to limit the
noise level. This function has an effect only in Automatic
mode.
Use of this function can reduce the comfort.
The unit has one input which can be used to have a function
controlled by an external accessory such as a door switch,
thermostat or a signal from a building management system
(BMS).
If several units are connected to one control panel, only one
input can be used. The effect of this input is then the same for
all the units.
Unit OFF locally
The function
whose inputs are in use.
When the timer is in use, the function
input on the unit is deactivated, irrespective of this setting.
All units OFF
With the setting
closed) settings, a jumper must be laid to the input for all the
other connected units.
See also section 2.8.
The unit has an interface for two output signals: These can be
used, for example, for controlling the central heating or
cooling system, or for transmitting status reports to a BMS.
The outputs function independently of one another.
O
PERATION
60. Function of input
.
61a/b. Function of output
.
has an effect only on the units
All units ON/OFF
and with the NC (normally
is
of the
43