Biddle CA2 Manual page 24

I
NSTALLATION
1
1
2
3
24
Connect the unit
w
Warning:
Make sure that the power supply you are working
on is switched off.
1. Fit the isolation switch and connect it to the power supply.
2. Remove the inspection panel:
- Remove the screws 1.
- Pull the panel a little forward and take it away.
1
1
c
Caution:
The whole panel will come loose when you pull it forward:
Take care it does not fall down.
3. Fix the cable gland 2 to the unit.
4. Lead the power supply cable through the cable swivel.
5. Connect the cable to the terminal 3 in the unit according
to the wiring diagram.
n
Note:
The design in your unit may differ from the illustration.
C A C
OMFORT IR URTAIN