Biddle CA2 Manual page 30

I
NSTALLATION
4
30
2.9.2 Finishing recessed models
General
n
Adjusting the discharge duct
If linking two or more units to each other, you must adjust the
discharge duct so that the finishing edges will not be in each
other's way.
1. Remove the end piece with finishing edge 1.
1
2. Mount the end piece without finishing edge 2.
2
Installing the discharge duct
3. Make a hole in the ceiling for the discharge (for
4. Fix the two angle sections3 with sheet metal screws to
5. Slide the discharge duct 4 into the discharge opening until
3
Note:
Ensure that the unit remains accessible for maintenance
and repair through, for instance, an inspection hatch.
dimensions, see Table 2-3).
the unit, along the edges of the discharge opening.
the desired height is reached.
C A C
OMFORT IR URTAIN