Biddle CA2 Manual page 38

O
PERATION
38
3.4.1 Automatic or manual control
The air curtain has an automatic and a manual mode. These
can be selected by touching the uppermost part of the air
curtain icon.
When the unit is switched on, it is always in automatic mode.
If you wish to operate the unit only in manual mode, switch off
the automatic mode via
3.4.2 Adjust the strength of the air curtain
Adjust the automatic strength control
In automatic mode, the strength and temperature of the air
stream are controlled automatically. Due to weather
conditions, you might want to adjust the automatic setting. If
you feel a cold draught along the floor, you can increase the
automatic strength.
n
Note:
The adjustment of the automatic strength is not always
directly translated into a different fan speed.
Manual setting of the strength
With the manual setting, you have 6 strengths to chose from.
To achieve maximum climate separation with minimum energy
consumption, Biddle recommends to select the lowest
strength at which no draught occurs. This setting may need to
be changed during the day.
3.4.3 Recommended setting of the air curtain
To obtain the maximum separation effect and the greatest
comfort possible with the least possible energy consumption,
Biddle recommends use of the fully automatic CHIPS control.
3.4.4 Controlling the temperature
You can set the temperature to a comfortable level. This is the
temperature at the air curtain.
With units connected to a Daikin system (CA
the temperature control is less accurate than with water or
electric heating.
C
OMFORT
Menu Settings 1. Select modes
> >
V and CA
2
A C
IR URTAIN
.
Q),
2