Configuration - Biddle CA2 Manual

O
PERATION
9. Calibration
11. Standard settings
3.9

Configuration

50. Access protection
51. Indoor sensor
52. Function of ON/OFF button
53. Control panel input
42
An unfavourable position of the operating panel or using the
temperature sensor in the air curtain can be the reason why
the temperature displayed differs from the real temperature.
Use this function to adjust the temperature reading.
Restores the standard factory settings. The settings made in
Configuration
the menu are retained.
The Configuration menu allows you to make settings to adjust
the operation of the unit to the room and the system. Usually,
this level is used only for installation, maintenance and service
purposes.
Access to the whole operating panel or only to the menu can
be protected with a four-digit PIN code.
The default PIN code is 0000.
Both the unit and the operating panel have a sensor which
measures the indoor temperature. Choose one that the
system is to use:
• Select the sensor on the unit for automatic control. This is
the standard setting.
• Select the sensor on the control panel if you also wish to
use the air curtain for heating the room. In this case
comfort may be reduced by draughts along the floor.
The unit can be switched ON and OFF manually. It can also be
switched ON and OFF via the internal timer or via an external
release signal at the input of the operating panel or of the unit.
In this case you can disable the manual switching ON and OFF.
ON/OFF
The button is then not displayed on the
The control panel has one input signal interface. This can be
used for an external ON/OFF signal or for an additional
temperature sensor.
When the timer is in use, the ON/OFF function of the input of
the control panel is deactivated, irrespective of this setting.
If an additional temperature sensor is connected, this takes
over the function of the sensor in the control panel.
C A C
OMFORT IR URTAIN
Home screen
.