Cable Adjustment - Bowflex The Ultimate 2 Assembly Instructions Manual

2
STEP 19
Parts:
• Squat Frame (Box 2)
• Shoulder Bars (Box 2)
Tool:
• Hex Key (3/16") and (5/32")
• Wrench (1/2") & (7/16") - or Adjustable Wrench
19-1 P osition Shoulder Bars against back of
Squat Frame with bend in arms pointing
towards the front of the frame.
19-2 I nstall and completely tighten the side screws,
washers and nylock nuts.
19-2 R emove the hardware securing the Lock Pin
Assembly to the Squat Frame.
19-3 A lign holes in Lock Pin Assembly and
Squat Frame.
19-4 Re-install and completely tighten Lock Pin
Assembly hardware.
Hardware (1:1):
4 Pan Head Allen Bolt (5/16" X 1 3/4")

Cable Adjustment

The Release Cable should be adjusted so
that there is enough tension to keep the
cable from laying on the metal frame. In
most cases this adjustment will be fine out
of the box. If the cable needs adjustment,
loosen the locknut and turn the Adjusting
Barrel counter-clockwise until cable is taut.
The release cable may stretch with use.
Check the cable tension regularly and
adjust if needed.
Assembling Your Bowflex Ultimate
Left Shoulder Bar
5/16" Nylock Nut
1/4" Nylock Nut
8 Washers (5/16")
Release Cable
Right Shoulder Bar
(has handle and cable)
Washer
Lock Pin Assembly
4 Nylock Nut (5/16")
Lock
Nut
2
®
Button Head Screw
(1/4" x 3/4")
Squat Frame
Side Screw
Button Head (5/16" x 1 3/4")
Adjusting Barrel
Metal Frame