Bowflex The Ultimate 2 Assembly Instructions Manual page 16


STEP 3 – Use two people for this step!
Parts:
• Front Base Assembly
• Rear Base Platform (Box 2)
Tool:
• Hex Key (7/32")
• Wrench (9/16") - or Adjustable Wrench
3-1 Remove Wire Ties from Bushings.
3-2 S lide Front Base toward rear base until the
Locking Pins make contact with the side plates.
MAKE SURE the Flanges slide over the Bushings
during this procedure. (See Top Detail View)
3-3 S queeze the Front Handle to retract the Locking
Pins, lift the handle about 3-4 inches and push
Front Base completely into the Rear Base.
Release the handle and make sure the Locking
Pins protrude through the Side Plates.
3-4 I nsert the Button Head Bolt and Washer then
squeeze Front Handle and fold Front Base up to
install Inside Washer and Hex nut. Completely
tighten hardware.
C
Pan Head Allen Bolt
Washer
Hardware (1:1):
2 Pan Head Allen Bolt (3/8" X 3")
Assembling Your Bowflex Ultimate
D
Remove Wire Ties from
Bushings
Bushings
Slide Front Base
towards Back Base
Until it Contacts Pins
Squeeze Handle and
Fold Front Base up
to install Nylock Nut
and Washer
Washer
2 Nylock Nut (3/8")
4 Washers (3/8")
2
®
Locking Pin
TOP DETAIL VIEW
Make sure Flanges
slide over Bushings
TOP DETAIL VIEW
Nylock Nut
A
Rear Base
Platform
B
Side Plate
Side Plate
Locking Pin