Bowflex The Ultimate 2 Assembly Instructions Manual page 31

Cable Installation STEP 1
Tool:
• Hex Key (7/32")
• Wrench (9/16") - or Adjustable Wrench
a. Uncoil cable from Upper Pulley Slider.
b. R emove Ball Stop from the end of cable that is to
be routed through pulleys by sliding the outer ball
back from the cable end and pushing out the slotted
insert. Slide the ball off of the cable and set aside.
(See Figure A)
c. R emove the pulley from the Upper Pulley Bracket,
wrap the cable over the pulley (See Figure B) and
reinsert the pulley back into the Upper Pulley
Bracket. Make sure the cable is inside the Side
Plate before moving on to STEP 2. (See Figure C)
Pulley
Installing Your Bowflex Ultimate
Remove Pulley from
Upper Pulley Bracket
Route Cable
Over Pulley
Figure B
2 Cables
®
Slide Ball Back
Remove Slotted Insert
Replace Pulley and Hardware
with Cable
Figure C
Cable End
Figure A
Cable Routed Inside
Side Plate
0