Bowflex The Ultimate 2 Assembly Instructions Manual page 20


STEP 8
(Do Not Tighten The Hardware For This Step Until Step 9 )
Parts:
• Lower Lat Tower Uprights (Box 4)
• Squat Holder (Box 4)
• Cross Brace (Box 4)
Tool:
• Hex Key (7/32")
8-1 I nsert Cross Brace and Squat Holder into Lower
Lat Tower Uprights. Make sure the Squat Holder
faces the the front of the Uprights. The label is
on the front and the screw holes are on the back
of the holder.
do not tighten
8-2 Install but
Step 9.
Hardware (1:1):
2 Pan Head Allen Bolt (3/8" X 3/4")
STEP 9
Parts:
• Lower Lat Tower Assembly (from step 8)
• Base Assembly
Tools:
• Hex Key (7/32")
• Wrench (9/16") - or Adjustable Wrench
9-1 P lace Lower Lat Tower over extrusions on
Base Assembly.
9-2 I nstall and completely tighten the hardware
from steps 8 and 9.
Hardware (1:1):
4 Pan Head Allen Bolt (3/8" X 3/4")
Assembling Your Bowflex Ultimate
the hardware until
2 Washers (3/8")
2 Pan Head Allen Bolt (3/8" X 2 1/2")
Pan Head Allen
Bolt
Squat Holder
The Cross Brace is on the
front of the Uprights
Lower Lat Tower
Assembly
Pan Head Allen Bolt
2 1/2"
Washer
2
®
Cross Brace
Label
Lower Lat Tower Uprights
Pan Head Allen Bolt
3/4"
(Rod Pack Not Shown
8 Washers (3/8") 2 Nylock Nuts
Nylock Nut
For Clarity)