Table of Contents
Advertisement
3-10
TURNING ON THE SERVER
T
urn on the server and follow the on-screen instructions for
IMPORTANT:
Some optional boards require setups with the SETUP utility before installation. If the
s
erver has a PCI board with the PCI-to-PCI bridge installed, the SETUP
e
nabled to launch. Check on the board specifications to find out whether it requires
p
re-i stallation setups before actually installing the board.
n
Some
installed optional devices or connected peripheral devices require setups before
proce
eding to the next step.
To use th
e server with no optional devices installed besides the graphic board, ins
desired o
perating system to the server.
1.
Make sure
th
at the floppy disk drive contains no f
CD-ROM
.
2.
Press the
POWER switch.
NOTES:
If the power cord is connected to the power control unit such as the UPS, turn on the
power control unit.
Connect the power cord and wait
switch. The POWER switch does not work for about 30 seconds after connecting the
p
ower cord due
D
o not turn off the server until characters following our logo appear on the screen. The
t
ime until the characters appear depends on your system configuration. Approximately,
it ma
y take one to five minutes.
POWER/SLEEP lamp
setup.
Before turning on the server:
loppy disk and the CD-ROM drive contains no bootable
for about 30 seconds before pressing the POWER
to BMC (Baseboard Management Controller) firmware start-up.
POWER switch
utility is
tall the
Advertisement
Table of Contents
