NEC Express5800 140He User Manual page 60

2-30
To take out the CD-ROM from the CD-ROM drive, press the Eject button in the similar way in setting the CD-ROM to
make the tray go out.
If the access lamp is lit in orange, the CD is
Eject button.
As shown in the figure above, hold the tray
another hand with the suppression of the rotor at the center of the tray to remove the CD-ROM from the t
A fter taking out the CD-ROM, return the tray into the drive.
W hen you fail to ej ect the CD-ROM tray with the Eject button and take out the CD-ROM from the server, follow the
procedu re below.
1.
Press the POWER switch to power off the server. (The POWER/SLEEP lamp goes off.)
2.
Insert a metal pin of approximately 1.2 mm in diameter and 100 m
will make a substitute) into the emergency hole on the upper front
until the tray is ejected.
IMPORT ANT:
Do not use a toothpick or plastic stick that is easy to break.
If the above procedure does not let you take out the CD-ROM, contact your service
representative.
3.
Hold the tray and pull it out.
4.
Take out the CD-ROM.
5.
Push the tray back into position.
being accessed. Confirm that the access lamp is not lit be
with a hand and take the end of the CD-ROM lightly by the fing
Emergency hole
fore pressing the
ray
m in length (a straightened large paper clip
of the CD-ROM drive and gently push it in
ers of
.