Table of Contents
Advertisement
9-16
6.
Connect the interface cable.
Connect the SCSI and power cables secured in the 5.25-inch device bay to the 5.25-inch device.
IMPORTANT:
future use.
7.
Push the 5.25-inch device to the device bay carefully until a click occurs to lock it.
IMPORTANT:
Connector pin bending or incomplete connection may cause a malfunction to occur.
Provide the connection securely watching the 5.25-inch device and cable connectors.
NOTE:
Make sure that the cable is not caught.
8.
Close the front door.
9.
Provide the setup for the SCSI controller.
Refer to the manual that comes with the SCSI controller board for setup.
Removal
Remove the 5.25-inch device in the reverse procedure of the installation.
A connector cap is attached to the power cable. Keep the removed cap for
Advertisement
Table of Contents
