Table of Contents
Advertisement
F1
T
T
If me
ssage "Press <F1>
"E
rror messages during POST" for the information on the messages and the proper
actions
against the errors. If an error message appears, pressing F1 allows the BIOS
setup u
tility to be started.
7.
When a passw
ord is set in the BIOS setup utilit
appears after th
e normal termination of POST.
The assword can be entered for up to three times. If you enter the password incorrectly all the time, the
p
serv cannot be started. In this case, turn off the power of the server, wait for about 10 seconds, and then turn
er
on th
e power to start the server again.
I
MPORTANT:
8.
Starts
operating system at the termination of POST.
POST Error Messages
When PO
ST d tects an error, it displays an error message on the screen. See Ch
e
IMPORTANT:
representative. Alarm messages are useful information for maintenance.
Po
wer Off
Follow the procedure b
elow to power off the server. If the power cord of the server is connected to a UPS, refer to the
manual that comes w
ith the UPS or the manual for the application that controls the UPS.
IMPORTANT: Always allow POST to complete before turning off the server.
1.
Shut down the operating system.
2.
Press the POWER switch on the front of the server.
The POWER/SLEEP lamp goes off.
3.
Power off peripheral devices.
to resume" appears, an error is detected during POST. See
y SETUP, the screen prompting you to enter the password
Set the password only after operating system is installed.
Take a note on the messages displayed before contacting your service
apter 8 for POST error codes.
2-25
Advertisement
Table of Contents
