Table of Contents
Advertisement
Setting hot spare
Procedure
1.
Install a hard disk to be used as hot spare, and then turn the server on.
2.
Start MegaRAID Configuration Utility to check each setting parameter.
Select "Objects" → "Physical Drive" from the TOP menu to display the "Objects - PHYSICAL DRIVE
3.
SELECTION MENU" screen shown below.
4.
Move the cursor onto the hard disk to be used as hot spare and press Enter.
5.
The "Channel X,Target X" screen appears. Select "Make HotSpare."
6.
A confirmation screen appears. Select "Yes."
7.
The hard disk display is changed to "HOTSP."
Install a hard disk
Start MegaRAID Configuration Utility
Check/set parameters
Exit MegaRAID Configuration Utility
4-39
Advertisement
Table of Contents
